Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
81
The parameters have the following meaning:
Parameter
Description
Range of values / note
ip
Keyword for an IPv4 address
-
ip-address
IPv4 address of the destination
Enter a valid IPv4 address.
ipv6
Keyword for an IPv6 address
-
ip6-address
IPv6 address of the destination
Enter a valid IPv6 address.
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The tracing of the route is activated.
Further notes
You display the route with the
show traceroute
command.
3.1.12
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal
command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end
or
exit
command and are then in the
Privileged EXEC mode again.
3.1.12.1
cli-console-timeout
Description
With this command, you enable the automatic logout and you configure the timeout setting
for the CLI.
Note
No automatic logout from the CLI
If the connection is not terminated after the set time, check the setting of the "keepalive"
function on the Telnet client. If the set interval is shorter than the configured time, the lower
value applies. You have set, for example, 300 seconds for the automatic logout and 120
seconds for the "keepalive" function. In this case, a packet is sent every 120 seconds that
keeps the connection up.
