Siemens SCALANCE X-200RNA, Руководство по эксплуатации

Страница: 49 / 158

4.8 LEDs
4.8.1 SCALANCE X-200RNA (PRP)
4.8.1.1 Fault LED
If the LED is lit red, a SCALANCE X-200RNA (PRP) has detected an error/fault.
At the same time, the signaling contact opens assuming that the response of the signaling
contact has not been configured differently.
The LED signals that the SCALANCE X-200RNA (PRP) can adopt the following statuses:
Device type SCALANCE LED lit red LED lit yellow LED not lit
X204RNA (PRP) 1, 2, 3, 4, 5 6 7
X204RNA EEC (PRP) 1, 3, 4, 5 6 7
X204RNA EEC (PRP/HSR)
If configured as PRP device.
1, 3, 4, 5 6 7
1. Link down event on a monitored port.
2. Failure of one of the two redundant power supplies.
3. C-PLUG error.
4. Device startup, the LED is lit for approx. 20 seconds.
5. Internal error.
6. A redundancy error was detected.
7. No problem has been detected by the SCALANCE X-200RNA (PRP).
4.8.1.2 Power LED
The LEDs signal the following statuses of the SCALANCE X-200RNA (PRP).
The status of the power supply is indicated by a green LED:
Device type SCALANCE LED lit green LED lit yellow LED not lit
X204RNA (PRP) 1 2 3
X204RNA EEC (PRP) 4 - 5
X204RNA EEC (PRP/HSR)
If configured as PRP device.
4 - 5
1. Both L power supplies are connected
(redundant supply).
2. One L power supply is connected
(non-redundant supply).
3. Power supply L1 and L2 are not connected or supply voltages are <14 V.
Descriptions of the products
4.8 LEDs
SCALANCE X-200RNA
Operating Instructions, 10/2016, C79000-G8976-C342-04
49