Siemens scalance WLC711, Справочное руководство

Страница: 81 / 417

5
ap Commands
ap Context
AP Common Commands
Radio Commands
DCS Commands
Serial Commands
This chapter describes commands required to manage the basic functions of the Wireless APs on the
system. The commands in this chapter are under the ap context of the CLI.
All CLI commands cache changes. For this reason, sometimes when you make a change in a particular
context, the change may not be visible immediately. If this happens, you must exit and re-enter the
context in order to ensure that the database is synchronized with the latest change.
There are many configurable parameters pertaining to wireless access points. Some commands are
common to all AP contexts and some apply only to specific AP contexts. To avoid repetition and
confusion, this chapter on AP configuration is organized into the following sections:
•
ap Context on page 82
Lists and describes commands available in the ap: context. The ap: context is the highest-level
context for AP configuration. Commands for configuration of specific AP models (such as 11n or
37xx) are located in the
defaults on page 86: context, and commands for configuration of
individual APs (by serial number) are located in the < serial on page 105>: context.
•
AP Common Commands on page 107
Commands that are common in multiple contexts are listed and described as AP Common
Commands on page 107.
•
Radio Commands on page 117
Radio commands, which are common to all APs (but vary from one AP type to another, and from
Radio1 to Radio2) are listed and described in the
Radio Commands on page 117 section.
•
DCS Commands on page 140
DCS commands, all of which are common to some radio command contexts, are in the DCS
Commands on page 140 section.
•
Serial Commands on page 144
Serial commands, in the <serial>: context, are commands for configuring a specific Wireless AP (by
serial number). Serial commands that are common to other ap: contexts are located in the
AP
Common Commands on page 107 section. Commands that are available only to the <serial>:
context are located in the Serial Commands on page 144 section.
SCALANCE WLC711 CLI Reference Guide 81