en
Rinse aid
12
1.
Open the dispenser
1Z
by pressing
and lifting the plate on the cover.
2.
Carefully pour rinse aid up
to the max. mark in the filler opening.
3.
Close cover until it clicks shut.
4.
To prevent excessive foam formation
during the next rinse cycle, remove
any rinse aid which has run over with
a cloth.
Setting amount of rinse aid
The amount of rinse aid dispensed can
be set from
§
:
‹‹
to
§
:
‹‡
. Set
the amount of rinse aid to be dispensed
to
§
:
‹…
to obtain a very good drying
result. The the factory setting is
§
:
‹…
.
Do not change the amount of rinse aid
unless streaks (select lower setting)
or water stains (select higher setting)
are left on the utensils.
1.
Close the door.
2.
Switch on ON/OFF switch
(
.
3.
Press and hold down the START
button
8
.
4.
Rotate programme selector
0
until
§
:
‹
... is indicated on the digital
display
@
.
5.
Release button.
The factory-set value
§
:
‹…
is lit on the digital display
@
.
To change the setting:
1.
Rotate programme selector
0
until
the required value is indicated on the
digital display
@
.
2.
Press START button
8
.
The set value is saved.
Switching off rinse aid refill
indicator
If the rinse-aid refill indicator
X
is
impaired (e.g. when using combined
detergents containing rinse aid
component), it can be switched off.
ヽ
Proceed as described under “Setting
amount of rinse aid” and set the
value to
§
:
‹‹
.
The rinse aid refill indicator
X
is now
switched off.
2
1
PD[
Содержание SC73E610TI
Страница 2: ...6WDUW 5HVHW VHF ...