Siemens RUGGEDCOM WIN7014, Руководство по установке

Страница: 12 / 48

Chapter 1
Introduction
RUGGEDCOM WIN7014
Installation Guide
4 Required Tools and Materials
CAUTION!
Security hazard - risk of unauthorized access and/or exploitation. Restrict access
to the serial console port to authorized personnel only.
ANT1 and ANT2 Ports N-type female ports for connecting RF (Radio Frequency) antennas. Use only RG-6 or RG-9
coaxial cables.
GPS Port A TNC female port for connecting the GPS antenna.
DC/ETH Ports A Power-over-Ethernet (PoE) port for supplying power to the base station and connecting it
to the network.
F/O Port For SFA and SFD models only. . An LC (Lucent Connector) port for connecting to the
network via a 1000Base-LX fiber optic Ethernet cable.
Section 1.3
Required Tools and Materials
The following tools and materials are required to install the RUGGEDCOM WIN7014:
Kits
• Class I, Division 2 Kit (P/N MKIT0109) – For hazardous
locations only
Tools
• Wrench or socket set
• Phillips screwdriver
• Drill with an 8 mm (5/16 in) drill bit
Sprays
• Cleaner and de-greaser
• SCC3 conformal coating
• Corrosion protection
Greases
• Marine grease (for marine applications only)
Tapes
• POE cold shrink (maximum 49.2 mm or 1.9 in inner
diameter before shrinking) or self-amalgamating tape
• UV-resistant vinyl tape
• Electrical insulation putty
Mounting Hardware (Wall/Tower Only)
• Four 8 mm (5/16 in) screws
• Four 8 mm (5/16 in) flat washers
• Four 8 mm (5/16 in) spring washers
• Wall anchors (if necessary)
Section 1.4
Decommissioning and Disposal
Proper decomissioning and disposal of this device is important to prevent malicious users from obtaining
proprietary information and to protect the environment.
Decommissioning
This device may include sensitive, proprietary data. Before taking the device out of service, either permanently or
for maintenance by a third-party, make sure it has been fully decommissioned.
For more information, refer to the associated
User Guide .