Siemens RUGGEDCOM RS910W, Руководство по установке

Страница: 48 / 52

Chapter 6
Certification
RUGGEDCOM RS910W
Installation Guide
38 FCC
• CAN/CSA-C22.2 No. 142-M1987
Process Control Equipment Industrial Products
• CAN/CSA-C22.2 No. 213-16
Non-Incendive Electrical Equipment for Use in Class I and II, Division 2 and Class III, Divisions 1 and 2 Hazardous
(Classified) Locations (Bi-National Standard with ANSI/ISA-12.12.01-2016)
• UL 916
Standard for Energy Management Equipment
• ANSI/ISA-12.12.01-2015
Non-Incendive Electrical Equipment for Use in Class I and II, Division 2 and Class III, Division 1 and 2 Hazardous
(Classified) Locations
It is specifically approved for use in hazardous locations with the following markings:
• Class I, Division 2, Groups A, B, C, D
• Temperature rating T6 at 40 °C and T4A at 85 °C
Section 6.1.2
FCC
This device has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment.
This device generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case users will be required to
correct the interference at their own expense.
This device further complies with Part 15, sub-part C of the FCC rules and is approved under the ID VG5RW80G.
IMPORTANT!
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate this device.
Section 6.1.3
FDA/CDRH
This device meets the requirements of the following U.S. Food and Drug Administration (FDA) standard:
• Title 21 Code of Federal Regulations (CFR) – Chapter I – Sub-chapter J – Radiological Health
Section 6.1.4
ISED
This device is declared by Siemens Canada Ltd to meet the requirements of the following ISED (Innovation Science
and Economic Development Canada) standard:
• CAN ICES-3 (A)/NMB-3 (A)