Siemens RUGGEDCOM RS900W, Руководство по установке

Страница: 19 / 44

RUGGEDCOM RS900W
Installation Guide
Chapter 2
Installing the Device
Mounting the Device to a Panel 9
Section 2.5.2
Mounting the Device to a Panel
For panel installations, the RUGGEDCOM RS900W can be equipped with panel adapters pre-installed on the top
and bottom of the chassis. The adapters allow the device to be attached to a panel using screws.
To mount the device to a panel, do the following:
1. Prepare mounting holes in the panel where the device is to be installed.
2. Place the device against the panel and align the adapters with the mounting holes.
2 1
2 1
Figure 3: Panel Mounting
1. Panel Mount Adapter 2. Screw
3. Secure the adapters to the panel with #6-32 screws.
Section 2.6
Connecting the Antennas
The RUGGEDCOM RS900W supports two dipole antennas that can be rotated 360° around the connection point,
and up to 90° at the joint for optimal positioning.
NOTE
The RUGGEDCOM RS900W is shipped with two 2.4 GHz dipole antennas.