Siemens RUGGEDCOM RS416PF, Руководство по установке

Страница: 35 / 56

Communication Ports
4.2 PoE Ports
WARNING
Electric shock hazard – risk of serious personal injury and/or equipment
interference
If shielded cables are used, make sure the shielded cables do not form a ground loop
via the shield wire and the RJ45 receptacles at either end. Ground loops can cause
excessive noise and interference, but more importantly, create a potential shock
hazard that can result in serious injury.
LEDs
Each port features a dedicated LED that indicates the state of the port.
State Description
Yellow (Solid) Link established
Yellow (Blinking) Transmitting/receiving
Off No link detected
Pin-Out
The following is the pin-out for the RJ45 male connectors:
8 1
Figure 4.2 RJ45 Ethernet Port Pin
Configuration
Pin Name Description
1 RX+ Receive Data+
2 RX- Receive Data-
3 TX+ Transmit Data+
4 Reserved (Do Not Connect)
5 Reserved (Do Not Connect)
6 TX- Transmit Data-
7 Reserved (Do Not Connect)
8 Reserved (Do Not Connect)
Specifications
For specifications on the available copper Ethernet ports, refer to "Copper Ethernet
Port Specifications (Page 36)" .
4.2 PoE Ports
The RUGGEDCOM RS416PF supports up to four 10/100Base-TX Power over Ethernet
(POE) ports powered by an external power supply. Each port complies with the IEEE
802.3af standard and features auto-sensing and automatic power off when cables
are removed.
PoE ports can be located in sets of two in slots 5 and 6.
26
RUGGEDCOM RS416PF
Installation Manual, 04/2021, C79000-G8976-1355-04