Siemens RUGGEDCOM RS1600F, Руководство по установке

Страница: 24 / 40

Device Management
3
This section describes how to connect to and manage the device.
3.1 Connecting to the Device
The following describes the various methods for accessing the RUGGEDCOM
RS1600F console and Web interfaces on the device. For more detailed instructions,
refer to the RUGGEDCOM RS1600F User Guide for the RUGGEDCOM RS1600F.
Serial Console Port
Connect a PC or terminal directly to the serial console port to access the boot-time
control and RUGGEDCOM ROS console interface.
IMPORTANT
The serial console port is intended to be used only as temporary connections during
initial configuration or troubleshooting.
The serial console port implements RS232 DCE (Data Communication Equipment) on
a DB9 connector. The following is the pin-out for the port:
5 1
6 9
Figure 3.1 Serial DB9 Console Port
Pin Name Description
1 DCD Data Carrier
Detect
2 RX Receive Data
3 TX Transmit Data
4 DTR Data Terminal
Ready
5 GND Signal Ground
6 DSR Data Set Ready
7 RTS Request
to Send
8 CTS Clear To Send
9 Reserved (Do Not Connect)
Communication Ports
Connect any of the available Ethernet ports on the device to a management switch
and access the RUGGEDCOM RS1600F console and Web interfaces via the device's IP
RUGGEDCOM RS1600F
Installation Manual, 01/2021, C79000-G8976-1014-03
15