Installing Device
2.1.2 Mounting the Device on a DIN Rail
2.1.2
Mounting the Device on a DIN Rail
For DIN rail installations, the RUGGEDCOM RS1600 can be equipped with panel/DIN
rail adapters pre-installed on each side of the chassis. The adapters allow the device
to be slid onto a standard 35 mm (1.4 in) DIN rail.
To mount the device to a DIN rail, do the following:
1. Align the adapters with the DIN rails and slide the device into place.
2
1
3
3
1
Panel/DIN Rail Adaptor
2
DIN Rail
3
Screw
Figure 2.2
DIN Rail Mounting
2. Install one of the supplied screws on either side of the device to secure the
adapters to the DIN rails.
2.1.3
Mounting the Device to a Panel
For panel installations, the RUGGEDCOM RS1600 can be equipped with panel/DIN rail
adapters pre-installed on each side of the chassis. The adapters allow the device to
be attached to a panel using screws.
RUGGEDCOM RS1600
Installation Manual, 01/2021, C79000-G8976-1013-03
9
