Siemens RUGGEDCOM ROX II, Руководство пользователя, Страница: 635 / 798

RUGGEDCOM ROX II
CLI User Guide
Chapter 13
Unicast and Multicast Routing
Adding a Static Multicast Group 589
Section 13.13.2.2
Adding a Static Multicast Group
To add a static multicast group, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the multicast group by typing:
routing multicast static mcast-groups description
Where:
•
description
is the name of the multicast group. Up to 32 characters are allowed, excluding spaces.
3. Configure the following parameter(s) as required:
Parameter Description
{ description } Synopsis: A string 1 to 32 characters long
Describes the multicast group, spaces are not allowed.
4. Configure out-interfaces. Refer to Section 13.13.3.2, “Adding an Out-Interface” .
5. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 13.13.2.3
Deleting a Static Multicast Group
To delete a static multicast group, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the multicast group by typing:
no
routing multicast static mcast-groups description
Where:
•
description
is the name of the multicast group to be deleted
3. Type commit and press Enter to save the changes, or type revert and press Enter to abort.
Section 13.13.3
Managing Out-Interfaces
An out-interface is the interface to which multicast packets are forwarded. Multiple out-interfaces can be defined
for each static multicast group.
CONTENTS
• Section 13.13.3.1, “Viewing a List of Out-Interfaces”
• Section 13.13.3.2, “Adding an Out-Interface”
• Section 13.13.3.3, “Deleting an Out-Interface”