Chapter 4
Device Management
RUGGEDCOM ROX II
CLI User Guide
102
Adding a VLAN to a Routable Ethernet Port
Section 4.18.3.2
Adding a VLAN to a Routable Ethernet Port
To add a VLAN to a routable Ethernet port, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the new VLAN by typing:
interface
eth
interface-name
vlan
id
Where:
•
interface-name
is the name of the interface
•
id
is the ID of the VLAN
3. Configure the following parameter(s) as required:
Parameter
Description
ip-address-src { ip-address-src }
Synopsis:
{ static, dynamic }
Default:
static
Whether the IP address is static or dynamically assigned via DHCP or BOOTP. The
DYNAMIC option is a common case of a dynamically assigned IP address. It switches
between BOOTP and DHCP until it gets the response from the relevant server. It must be
static for non-management interfaces.
ipv6-address-src { ipv6-address-src }
Synopsis:
{ static, dynamic }
Default:
static
Whether the IPv6 address is static or dynamically assigned via DHCPv6. Option DYNAMIC
is a common case of a dynamically assigned IPv6 address. This must be static for non-
management interfaces.
on-demand
This interface is up or down on the demand of the link failover.
4. Add a QoS map for the VLAN. For more information, refer to
Section 16.2.7.2, “Adding a QoS Map”
.
5. Type
commit
and press
Enter
to save the changes, or type
revert
and press
Enter
to abort.
Section 4.18.3.3
Deleting a VLAN for a Routable Ethernet Port
To delete a VLAN configured for either a routable Ethernet port or virtual switch, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the traffic control rule by typing:
no
interface eth
name
vlan
id
Where:
•
name
is the name of the interface
•
id
is the ID of the VLAN
3. Type
commit
and press
Enter
to save the changes, or type
revert
and press
Enter
to abort.
Содержание RUGGEDCOM ROX II
