Siemens MS Series, Инструкция по эксплуатации, Страница: 124 / 130

HART Communicator *) Measured value display
Operating structure SITRANS P MS
2 Online 1 Pressure
2+ Configure 1 Process variables *) 1 Pressure
2 % MR
3 Current
4 Sens-Temp
2 Diagnosis/Service 1 Test/Status 1 Test 1 Current transmitter
2 Self-test
3 Reset
2 Status
2 Access control 1 Local operation
2 Write prot. No
3 Set write prot.
3 Adjustment 1 Pos. error adjust.
2 Sensor adjust.
1 Adjust. point
2 Zero adjustment
3 Lower adjustment
4 Upper adjustment
3 Sys. out. adjust. 1 D/A adj 4mA/20mA
2 D/A adj scaled
4 Reset factory adj
5 All measured values 1 Pressure
2 Basic value
3 Sens Temp
4 El Temp
5 Current
3 Quick setup 1 Meas tag (TAG)
2 Unit
3 Pos. error adj.
4 Start of scale
5 Full scale
6 Damping
7 Characteristic
4 Complete setup 1 Sensors 1 Pressure sensor 1 Pressure
2 Unit
2 Temperatur sensor 1 Sens Temp
2 El Temp
2 Signal parameter 1 Process variables *) 1 Pressure
2 % MB
4 Current
5 Sens temp
2 Pos. error adj.
3 Set zero/span
1 Keyboard input
2 Press. default
4 Damping
5 Characteristic
6 Start squ. Rooting
7 Meas. speed
3 Output parameters 1 Analog output 1 Current
2 Pressure % MR+L34
3 Alarms
4 Low. current limit
5 Up. current limit
2 HART output 1 Call address
2 Dis call preamb.
3 Dis reply preamb.
4 Device info 1 Range & limits 1 Range cell
2 Press up. sens. lim.
3 Press low. sens. lim.
4 Press. min. span
2 Gen. device info 1 Made by Siemens
2 Model
3 Transmitter type
4 Order no.
5 Explosion prot.
6 Serial no.
7 Pressens ser.no.
8 Assembly no.
9 Electr connection
Electr. housing mat.
Write prot. No
Meas. tag (TAG)
MM/DD/YY 10/10/10
Description
Message
3 Sensor Info 1 Process conn.
2 Flange type
3 Flange mat.
4 Process fl. screw
5 Seal diaph. mat.
6 Cell filling mat.
7 O-ring mat
8 Vent/plug mat.
9 Vent/plug pos.
4 Remote seal 1 Re. seal type
2 Seal diaph. mat.
3 Seal filling med.
4 No. of rem. seals
5 Tube length
5 Local display 1 Dispay type
2 Up. unit
3 Local unit display
4 Bargraph
6 Revision numbers 1 Universal Rev.
2 Field dev. Rev.
3 Software Rev.
4 Hardware Rev.
5 Overview