Siemens KT..R Series, Инструкция по установке и эксплуатации

Страница: 11 / 18

en
11
Cleaning the appliance
ã=
Caution
■
Do not use abrasive or acidic cleaning
agents and solvents.
■
Do not use scouring or abrasive
sponges. The metallic surfaces could
corrode.
■
Never clean shelves and containers in
the dishwasher. The parts may
become deformed!
Proceed as follows:
1. Before cleaning: Switch the appliance
off.
2. Pull out the mains plug or switch off
the fuse.
3. Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing-up liquid. The rinsing water
must not run into the light.
4. Wipe the door seal with clear water
only and then wipe dry thoroughly.
5. Rinsing water must not run through
the drainage hole into the evaporation
area.
6. After cleaning reconnect and switch
the appliance back on.
Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Take out glass shelves
Fig. 6
Lift the glass shelves, pull forwards,
lower and swing out to the side.
Condensation channel
Fig.
*
Regularly clean the condensation
channel and drainage hole with a cotton
bud or similar implement to ensure that
the condensation can drain.
Take out shelves in the door
Fig. +
Lift shelves upwards and take out.
Light (LED)
Your appliance features a maintenance-
free LED light.
These lights may be repaired
by customer service or authorised
technicians only.
Tips for saving energy
■
Install the appliance in a dry, well
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
■
Allow warm food and drinks to cool
down before placing in the appliance!
■
When thawing frozen products, place
them in the refrigerator. Use
the coldness of the frozen food
to cool food.
■
Open the appliance as briefly
as possible.
■
Occasionally clean
the rear of the appliance
with a vacuum cleaner or paint brush
to prevent an increased power
consumption.