Siemens KI25R Series, Инструкция по эксплуатации

Страница: 23 / 78

en
23
Operating tips
■
While the refrigeration unit is running,
water droplets or a thin layer of ice
may form at the rear panel of
the refrigerator. This is nothing
unusual. It is not necessary to scrape
off the frost or wipe off the water
droplets. The rear panel defrosts
automatically. The condensation
collects in the condensation channel
and is carried to the refrigeration unit
where it evaporates.
■
If the air humidity is high,
condensation may form
in the refrigerator compartment,
especially on the glass shelves. If this
is the case, pack or wrap the food
and select a lower temperature
in the refrigerator compartment.
Setting the
temperature
Fig.
2
The temperature can be set from
+2 °C to +8 °C.
Keep pressing temperature setting
button 3 until the required refrigerator
compartment temperature is set.
The value last selected is saved. The set
temperature is indicated on the
temperature display 4.
Super cooling
Super cooling sets the refrigerator
temperature to the coldest temperature
setting for approx. 6 hours. Then
the appliance automatically switches
to the temperature set prior to super
cooling mode.
Switch on super cooling mode, e.g.
■
before placing large quantities of food
in the refrigerator compartment.
■
for the fast cooling of drinks.
Switching on and off
Fig. 2
Press “super” button 2.
The button is lit when super cooling is
switched on.
Note
When super cooling is switched on,
increased operating noises may occur.
Alarm function
Door alarm
The door alarm (continuous sound)
switches on if the appliance door is open
for longer than two minutes. Close
the door to switch off the warning signal.
Switching off the alarm
Fig. 2
Press the alarm button 1 to switch off
the warning signal.