Siemens iQ700 SX87Y801BE, Инструкция по применению

Страница: 29 / 60

Water softening system
en
29
11.4 Switching off the water
softening system
If you find the special salt refill indic-
ator irritating, e.g. when using com-
bined detergents with salt replace-
ment substances, you can switch the
indicator off.
Note
To avoid damage to the appliance,
only switch off the water softening
system in the following cases:
¡
The water hardness is max. 26 °E
and you are using a combined de-
tergent with salt replacement sub-
stances. According to the manu-
facturers, combined detergents
with salt replacement substances
can generally only be used up to a
water hardness of 26 °E without
adding special salt.
¡
The water hardness is 0 - 8 °E.
You do not need to use special
salt.
1.
Press ⁠.
2.
To open the basic settings, press
for approx. 3 seconds.
3.
Press repeatedly until the display
shows "Water hardness".
4.
Press or repeatedly until the
display shows 0 - 8.
5.
To save the settings, press for
approx. 3 seconds.
a
The water softening system is
switched off and the salt refill indic-
ator is deactivated.
11.5 Regeneration of the wa-
ter softening system
In order to obtain fault-free function of
the water softening system, the appli-
ance performs regeneration of the
water softening system at regular in-
tervals.
Regeneration of the water softening
system takes place before the end of
the main rinse cycle in all pro-
grammes. It will increase the run time
and consumption values, e.g. water
and electricity.
Overview of consumption values
with regeneration the water
softening system
Here you can find an overview of the
maximum additional running time and
consumption values during regenera-
tion of the water softening system.
Regeneration of the water
softening system after x
washing programmes 6
Additional running time in
minutes 7
Additional water consump-
tion in litres 5
Additional power consump-
tion in kWh 0.05
The consumption values specified
are laboratory measurements determ-
ined in accordance with the currently
applicable standard using the Eco
50° programme and with the factory
value of the water hardness set to 16
- 20 °E.