13
Setting the gas grill
1.
Open the top cover. The top cover must remain open for as
long as the cooker is in operation.
2.
Turn on the main gas supply to the appliance. Insert the plug
into the socket.
3.
Insert the protecting plate into the groove below the control
panel.
Insert the protecting plate with the longer edge at the front
and the curvature at the bottom.
Secure the protecting plate in the groove below the control
panel using the retainers.
Ensure that the protecting plate is engaged in the retainers. If
the protecting plate cannot be pulled out, it is engaged
correctly. You can now safely use the protecting plate. If it
can be removed, insert it into the groove at a slightly higher
angle and make sure that it engages in the retainers.
4.
Close the oven door so that it is as close as possible to the
protecting plate.
5.
Push in the function selector and turn it clockwise to the
ignition position
:
.
6.
Keep the function selector pressed in and turn it to the grill
setting
#
.
Keep the function selector pushed in for 10 seconds so that
the safety pilot starts up. The gas coming from the gas grill is
ignited.
7.
Check whether the flame is lit. If the flame goes out, repeat
the process from step 5.
8.
Switch off the function selector after 30 minutes. Once the
oven has cooled down, remove the protecting plate.
Caution!
The gas grill only works when the protecting plate is inserted.
Make sure that the protecting plate is correctly inserted.
Cleaning the accessories
Before you use the accessories for the first time, clean them
thoroughly with hot soapy water and a soft dish cloth.
Making settings on the hob
Your hob is equipped with four gas burners. The following
information explains how to light the gas burners and set the
size of flame.
Advance cleaning of burner cup and cap
Clean the burner cap (1) and cup (2) with water and washing-
up liquid. Dry the individual parts carefully.
Place the burner cup and cap back on the burner shell (5).
Ensure that the igniter (3) and flame safety pin (4) are not
damaged.
The nozzle (6) must be dry and clean. Always position the
burner cap exactly over the burner cup.
Igniting the gas burners
Always position the burner cap exactly over the burner cup.
Openings on the burner cup are always unobstructed. All parts
must be dry.
1.
Open the top cover. The top cover must remain open for as
long as the oven is in operation.
2.
Turn the knob for the desired burner anti-clockwise to the
ignition position
:
. Ignition begins.
3.
Press and hold the burner knob for 1-3 seconds. The gas
burner ignites.
The safety pilot is activated. If the gas flame goes out, the gas
supply is automatically interrupted by the safety pilot.
4.
Set the desired flame size. Between setting
û
Off and setting
•
, the flame is not stable. Therefore, always choose a setting
between
•
large and
–
small flame.
5.
If the flame goes out again, repeat the process from step 2.
6.
To end the cooking process: Turn the burner knob
û
clockwise to the Off position.
The ignition device should not be actuated for more than 15
seconds. If the burner does not light within 15 seconds, wait for
at least one minute. Then repeat the ignition process.
:
Caution!
If after switching the oven off you turn the burner knob while the
oven is still hot, gas will escape. +If you do not turn the knob to
the ignition position
:
, the gas supply will be interrupted after
60 seconds.
