Siemens HSL6EI231, Инструкция по установке

Страница: 18 / 56

18
Securing the appliance
1.
Slide the appliance all the way in and align it centrally.
Ensure that no power cables or connecting cables are
kinked, trapped or running over sharp edges.
2.
Remove both of the rubber profiles. In the holes there are
plastic sleeves which are required for fastening.
3.
Secure the appliance to the fitted unit using the 2 screws.
4.
Put the rubber profiles back on.
Removing the appliance
1.
Disconnect the appliance from the power supply.
2.
Shut off the gas supply.
3.
Undo the securing screws.
4.
Gently lift the appliance and pull it out completely.
5.
Disconnect the electric and gas connections in accordance
with regulations.
Converting the gas type
If the appliance is not already set up for the existing type of
gas, the appliance must be converted. The conversion to a
different type of gas must be carried out by an authorised
expert in accordance with the applicable regulations. The rating
plate indicates the type of gas and the gas pressure which
have been pre-set in the factory.
The rating plate is on the side of the oven door.
In order to convert to a different type of gas, the nozzles must
be replaced and the low flame must be adjusted.
Oven burner
Replacing the nozzles
1.
Remove the floor plate from the oven by lifting the floor
slightly at the front and then pulling it out towards the front.
2.
Undo the screw for the rear holder.
3.
Unscrew the screw on the front and pull the burner forwards
out of the gas connection.
4.
Unscrew the nozzle and replace it with a nozzle which is
suitable for the new type of gas (see "General nozzle table"
section).
5.
Replace the gas label with the new label that was supplied
with the nozzle set.
6.
To reassemble the oven burner and the floor plate, follow the
instructions in reverse order.