en
Rails
36
6.
Push the inner pane upwards until it is in the left-
and right-hand retainers .
7.
Put the door cover into position and push down
on it until you hear it click into place.
8.
Open the appliance door fully.
9.
Close the locking levers on the left- and right-hand
hinges .
a
The locking levers are closed. The appliance door is
secured and cannot be detached.
10.
Close the appliance door.
Note:
Do not use the cooking compartment again until
the door panes have been correctly fitted.
24 Rails
To thoroughly clean the rails and the cooking compart-
ment, or to replace the rails, you can remove the rails.
24.1 Detaching the rails
WARNING ‒ Risk of burns!
The shelf supports get very hot
▶
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
1.
Lift the rail forwards slightly and detach it .
2.
Pull the whole rail to the front and remove it.
3.
Clean the rail.
24.2 Attaching the rails
Notes
¡
The rails only fit on the right or left.
¡
For both rails, ensure that the curved rods are at the
front.
1.
First, push the rail into the middle of the rear
socket until the rail rests against the cooking
compartment wall, and then push this back .
2.
Push the rail into the front socket until the rail
also rests against the cooking compartment wall,
and then press this downwards .
24.3 Removing the pull-out rail
WARNING ‒ Risk of burns!
The shelf supports get very hot
▶
Never touch the shelf supports when hot.
▶
Always allow the appliance to cool down.
▶
Keep children at a safe distance.
ATTENTION!
The self-cleaning surfaces in the cooking compartment
may be damaged by detaching and attaching the pull-
out rails.
▶
Detach the rails before detaching or attaching the
pull-out rails.
Notes
¡
Depending on the appliance type, you must change
the basic settings for the telescopic rails for appli-
ances with rails and pull-out rails.
¡
The pull-out rails can be installed at any level as re-
quired.
¡
If necessary, you can equip all levels with a pull-out
rail.
