Trouble shooting
en
35
3.
Insert the front panel at the bottom into the retainers
(figure
#
).
4.
Close the front panel until both upper hooks are
opposite the opening (figure
$
).
5.
Press the front panel at the bottom until it clicks
audibly into place (figure
%
).
6.
Open the appliance door again slightly and remove
the tea towel.
7.
Screw both screws back in on the left and right.
8.
Put the cover back in place and press on it until it
clicks audibly into place (figure
&
).
9.
Close the appliance door.
Caution!
Do not use the cooking compartment again until the
panels have been correctly fitted.
3
Trouble shooting
Trouble shooting
If a fault occurs, there is often a simple explanation.
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Rectifying faults yourself
You can often easily rectify technical faults with the
appliance yourself.
If a dish does not turn out exactly as you wanted, you
can find useful cooking tips and instructions at the end
of this instruction manual.
Fault
Possible
cause
Notes/remedy
The appliance is
not working.
Defective cir-
cuit breaker.
Check the circuit breaker in the
fuse box.
Power failure Check whether the kitchen light
or other kitchen appliances are
working.
Steam-assisted
operation does
not start.
Water tank is
empty.
Fill the water tank.
Descaling
locks opera-
tions with
steam.
Carry out descaling.
Defective
steam sys-
tem.
Call after-sales service.
Cooked dishes
turn out too moist
or too dry when
cooking with
steam-assisted
applications
The wrong
steam inten-
sity was
selected
Select a higher or lower steam
intensity
Steam escapes
from the ventila-
tion slots during
cooking
Normal proce-
dure
Not possible
The "fill water
tank" symbol
lights up continu-
ously
No water in
the water
tank.
Fill the water tank.
The water
tank has not
been put in
fully.
Put the water tank in fully.
The sensor is
defective.
Call after-sales service.
The water
tank is leak-
ing.
Order a new water tank.
The time is flash-
ing on the display.
Power failure. Reset the time.
After an operating
mode is switched
on,
œ
is flashing
on the display.
The appliance
has not
cooled down
sufficiently.
Switch off the appliance, allow it
to cool down and switch on the
operating mode again.