en
Cleaning function
32
:
Warning
Risk of harm to health!
The cleaning function heats up the cooking
compartment to a very high temperature so that food
remnants left over from roasting, grilling and baking will
burn off.This process releases vapours, which can
irritate the mucous membranes. While the cleaning
function is running, keep the kitchen well ventilated. Do
not remain in the room for long periods. Keep children
and pets away. Follow the instructions even when using
the Delayed start function with a delayed end time.
Before running the cleaning function
Caution!
Before cleaning is started, remove the water tank from
the appliance.
You can leave the shelf supports and pull-out rails in the
cooking compartment when running the cleaning
function so that they are cleaned at the same time.
Before starting the cleaning function, remove the worst
of the food remnants manually.
Remove accessories and cookware from the cooking
compartment. Only by doing this will you ensure that
you achieve good cleaning results throughout the entire
cooking compartment.
Clean the inside of the appliance door and along the
edges of the cooking compartment in the area around
the seal. Do not scrub or remove the seal.
:
Warning
Risk of fire!
■
Loose food remnants, fat and meat juices may catch
fire when the cleaning function is in progress. Before
you start the cleaning function, always remove the
worst of the food residues and remnants from the
cooking compartment.Do not use the cleaning
function for cleaning accessories.
Risk of fire!
■
The appliance will become very hot on the outside
during the cleaning function. Never hang
combustible objects, e.g. tea towels, on the door
handle. Do not place anything against the front of
the appliance. Keep children away from the
appliance.
Risk of fire!
■
If the door seal is damaged, a large amount of heat
will be generated around the door. Do not scrub or
remove the seal. Never operate the appliance if the
seal is damaged or missing.
:
Warning – Risk of serious harm to health!
The appliance becomes very hot when the cleaning
function is in progress. The non-stick coating on baking
trays and tins is destroyed and noxious gases are
released. Never clean non-stick baking trays or baking
tins using the cleaning function. In general, you must
not use the cleaning function for cleaning accessories.
Setting the self-cleaning function
1.
Press the
j
button.
The operating modes menu opens.
2.
Select the "Self-cleaning" operating mode.
Cleaning setting 3 is suggested. You can start the
cleaning process immediately using the
u
button
or
3.
select a different cleaning setting using the rotary
selector.
4.
Press the
u
button to start the cleaning operation.
Ventilate the kitchen when the cleaning function is
running.
The cooking compartment door locks shortly after
operation starts. The
H
symbol for the locking
mechanism appears on the right-hand side of the status
bar next to the elapsing duration.
The cooking compartment door cannot be opened until
the
H
symbol goes out in the status bar.
Once the cleaning has finished
An audible signal sounds. The oven stops heating.
“Finished” appears in the status bar. Use the
0
button
to switch off the audible signal.
Cancelling the cleaning operation
Use the
k
button to switch off the oven. The cooking
compartment door cannot be opened until the
H
symbol goes out in the status bar.
Adjusting the cleaning setting
Once cleaning starts, the cleaning setting can no longer
be changed.
You can set the cleaning to run overnight
In the section "Time settings", you can find out how to
delay the end time. This allows you to use the oven at
any time throughout the day.
Once the cleaning function has ended
Once the cooking compartment has cooled down, use
a damp cloth to wipe off the ash that has been left
behind in the cooking compartment, on the shelves and
around the appliance door.
Wipe the pull-out rails with a damp cloth. Then slide the
pull-out rails in and out several times. After cleaning,
some discolouration may remain on the pull-out rails.
This has no effect on performance.
Notes
■
During cleaning, the frame on the inside of the
appliance door may discolour. This is normal and
does not affect performance. The discolouration can
only be removed using a stainless-steel cleaning
agent.
■
Very bad soiling may cause white deposits to remain
on the enamel surfaces. This is residue from the
food and is harmless. It does not affect performance.
You can remove these residues using lemon juice if
required.
Содержание HN678G4.6W
Страница 2: ......