Siemens HiPath Series, Руководство пользователя

Страница: 48 / 62

Installing and configuring the Standalone Access Point
A31003-W1110-U101-1-7619, February 2007
48
HiPath Wireless Standalone Access Point V1.0, Getting Started Guide
HSAAP_Installing.fm
Connecting and powering the Standalone Access Point
4. Insert the plastic spreading rivet through the hole at the bottom of the bracket and into the
Standalone Access Point case. Then screw in the plastic screw. This spreads the rivet and
locks the case to the bracket. To remove the Standalone Access Point, use a screwdriver
to remove the screw.
4.2 Connecting and powering the Standalone Access Point
You can connect the LAN and power up the Standalone Access Points in one of three ways:
●
Power over Ethernet (PoE) – If your network is already set up with PoE, attach the LAN
ethernet cable to the RJ45 ethernet connector at the top of the Standalone Access Point.
For this method you can use a regular Ethernet cable.
●
Power over Ethernet: Adding a PoE injector – If your network is not set up with PoE, you
can provide power to the LAN ethernet cable with a PoE injector. The PoE injector must be
802.3af compliant. The PoE injector is not provided with the Standalone Access Point. If
you are using a PoE injector, refer to the manufacturer’s documentation for the necessary
requirements.
●
Power by AC adaptor – An AC adaptor for the Standalone Access Point is offered
separately. The specifications are:
●
Input: 120-240 VAC
●
Output Voltage: DC +6V, max amps 1.50, max watts 10
If you are using a direct connection to the Standalone Access Point you must use a cross-
over Ethernet cable.
Figure 3 Top and bottom views of Standalone Access Point
7
This device must not be connected to a LAN segment with outdoor wiring.
Ensure that all cables are run correctly to avoid strain. Replace the power supply
adapter immediately, if it shows any signs of damage.
>
To use an adaptor, install the Standalone Access Point within six feet (two
meters) of a wall outlet, attach the adaptor to the Standalone Access Point and
then plug the adaptor into the wall outlet.