Siemens HiNet LP5100, Руководство по эксплуатации и администрированию

Страница: 28 / 134

Operation
28
Dialing with handset replaced
You will hear the dial tone from the loudspeaker in the base unit.
As soon as the subscriber answers, you can pick up the handset
and make the conversation. During the conversation, you will see
the standard display for an active connection:
Switching handsfree/handset
You can replace the handset during a telephone call and continue
with the conversation in handsfree mode.
●
Keep the key "Loudspeaker" pressed and replace the hand-
set. The loudspeaker and the microphone in the base unit are
switched on.
You can pick up the handset during the telephone call in handsfree
mode in order to continue your call.
●
Pick up the handset during the handsfree call. The loudspea-
ker and the microphone in the base unit are switched off.
Switching loudspeaker on
If any persons present in the room should also hear what’s being
said during the telephone call that you are making by means of the
handset:
●
Press the key "Loudspeaker".
The voice of the called party can be heard over the loudspea-
ker in the base unit.
18:10
Page forward with 20.06.98
>
Display of the basic menu
722_
Dial?
Enter the call number
72261496
Dial?
Confirm the call number
entered
Press this key to hear the
dial tone
The loudspeaker is
switched on
72261496
calling
The dialing process is
confirmed
72261496
ringing The ringing tone signal
sounds
72261496
Consultation?
>
The active connection is
displayed