Operating the appliance
en
17
Using combi mode
Notes
■
The temperature range marked on the control knob
for the oven applies only when using conventional
heating. In combi mode, the temperature in the oven
is higher than the temperature that has been set.
■
When you use the gas grill on the lowest setting, you
must also set the oven to the lowest heat setting.
Switching on combination mode
1.
Open the appliance door.
2.
Press and hold the selector for the grill and turn it
anti-clockwise to the "Max." position.
The grill gas burner ignites. Press and hold the
selector for a few seconds until the flame stabilises.
3.
Carefully close the appliance door.
4.
Open the appliance door after 10 minutes.
5.
Press and hold the selector for the oven and turn it
anti-clockwise to the maximum temperature.
The oven gas burner ignites. Press and hold the
selector for a few seconds until the flame stabilises.
6.
Carefully close the appliance door.
7.
Set the required temperature using the selector for
the grill and oven.
8.
Wait 15 minutes for the oven to heat up. Carefully
open the appliance door and slide the baking try in.
Caution!
If the grill and oven gas burners are operating at the
same time (combined mode); When cooking with water,
the grill gas burner may go out due to the air circulation.
Notes
■
If the gas burner does not ignite within 15 seconds,
stop attempting to ignite the flame, open the oven
door and wait for 60 seconds.
■
If the flame goes out (but you have not deliberately
turned it off), turn the selector to the "
Û
" position and
wait for 60 seconds.
Switching on the grill
To achieve an extra gold top on certain dishes, the grill
can be switched on briefly at the end of the cooking
time when using conventional heating.
1.
Open the appliance door.
2.
Press and hold the selector for the grill and turn it
anti-clockwise to switch on the grill.
The grill gas burner ignites. Press and hold the
selector for a few seconds until the flame stabilises.
3.
Use the selector for the grill to set the required
temperature.
4.
Carefully close the appliance door.
Switching off combination mode
Turn the selector for the grill and oven to the
Û
position.
Rotary spit
Preparing the rotary spit
1.
Slide a retaining clip onto the rotary spit and screw
on the handle.
2.
Place the roast as close as possible to the centre of
the rotary spit.
3.
Use retaining clips to secure the roast in place.
4.
Use milled screws to secure the retaining clips.
Inserting the rotisserie spit
:
Warning – Risk of burns!
Never touch the hot surfaces of the cooking
compartment or the heating elements. Children must be
kept at a safe distance from the appliance at all times.
Open the appliance door carefully. Hot steam may
escape.
1.
Push the rotisserie spit rack fully into the appliance
on shelf level 3.
2.
Place the rotisserie spit onto the rotisserie spit rack
and unscrew the handle.
3.
Push the rotisserie spit rack in fully.
