15
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
Removal
1.
Detach the oven door and lay it on a cloth with the handle
facing down.
2.
Unscrew the cover at the top of the oven door. To do this,
undo the left and right screws (fig. A).
3.
Lift the top panel up and out (fig. B).
4.
Unscrew the retaining clips on the right and left. Lift the panel
and remove the brackets from the panel (fig. C). Take out the
panel.
Clean the panels with glass cleaner and a soft cloth.
Do not use sharp or abrasive materials or a glass scraper. This
may damage the glass.
Fitting
When fitting, make sure that the lettering "right above" is upside
down at the bottom left.
1.
Insert the panel diagonally towards the back (fig. A).
2.
Stick the retaining clips onto the right and left-hand sides of
the panel, aligning them so that the carriers are over the
screw holes, and then screw in place (fig. B).
3.
Insert the uppermost panel diagonally towards the back. The
smooth surface must face outwards.
4.
Put the cover back in place and screw it on.
5.
Attach the oven door.
Do not use the oven again until the panels have been
correctly fitted.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish doesn't turn out as well as you had hoped, refer to the
section
Tested for you in our cooking studio
, where you will
find plenty of cooking tips and tricks.
Error messages
If an error message with
“
appears, press the
0
button. Then
reset the clock. If the error message appears again, call the
after-sales service.
You can take remedial action yourself if the following error
messages are displayed.
%
$
&
%
$
Problem
Possible cause Remedy/information
The oven does
not work.
The circuit
breaker is
defective.
Look in the fuse box and
check that the circuit
breaker is in working order.
Power cut
Check whether the kitchen
light or other kitchen appli-
ances are working.
0
and three
zeros light up in
the display.
Power cut
Reset the clock.
The oven does
not heat up.
There is dust on
the contacts.
Turn the control knobs back
and forth several times.
The oven door
cannot be
opened. The
H
symbol lights
up in the dis-
play.
The oven door
is locked by
x
self-cleaning.
Wait until the oven has
cooled down and the
H
symbol goes out.
The oven does
not heat up. A
Ü
small square
lights up in the
display.
The oven is in
demonstration
mode.
Switch off the circuit
breaker in the fuse box and
switch it on again after
approximately 20 seconds.
Now, within approx.
2 minutes, press and hold
the
h
button for approx.
4 seconds until the
Ü
square goes out.
”‰
appears in
the display.
Automatic
switch-off has
been activated.
Turn the function selector to
the off position.
Problem
Possible cause Remedy/information
