Siemens HB53CR550, Инструкция по эксплуатации

Страница: 12 / 24

12
Cleaning the door panels
To facilitate cleaning, you can remove the inner door panels
from the appliance door.
ã=
Risk of injury!
The components inside the appliance door may have sharp
edges. Take care not to cut yourself. Wear protective gloves.
ã=
Risk of injury!
The appliance must not be used again until the door panels
and appliance door have been correctly fitted.
Removing the door panel
Note:
Before removing, make a note of the orientation in which
the door panel is fitted, so that it is not refitted the wrong way
round.
1.
Unhook the appliance door and lay it on a soft, clean surface
with the front side facing downwards (see section: Removing
and installing the appliance door).
2.
Unscrew the cover at the top left and right of the appliance
door and detach it (figure A).
3.
Lift the door panel and remove it (figure B).
Removing the intermediate panel
1.
Press the holder on the intermediate panel on one side and
unlatch it, using a spatula for instance (fig. C).
2.
Unlatch the other side in the same way and remove the
intermediate panel.
Cleaning
Clean the door panel with glass cleaner and a soft cloth.
Caution!
Do not use any sharp or abrasive medium or a glass scraper.
The glass could be damaged.
Fitting the intermediate panel
1.
Place the intermediate panel in the supports on the left and
right (figure D).
2.
Push the intermediate panel downwards in the retainers.
Fitting the door panel
1.
Slide in the door panel all the way.
2.
Put the cover back in place and screw it in.
3.
Refit the appliance door.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Malfunction table
If a dish doesn't turn out as well as you had hoped, refer to the
section Tested for you in our cooking studio , where you will
find plenty of cooking tips and tricks.
Error messages
If an error message with “ appears, press the 0 button. The
message disappears. A time function that has been set is
cleared. If the error message does not disappear, please
contact the after-sales service.
You can take remedial action yourself if the following error
message is displayed.
ã=
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
$ %
&
'
Problem Possible cause Remedy/information
The oven does
not work.
The circuit
breaker is
defective.
Look in the fuse box and
check that the circuit
breaker is in working order.
Power cut Check whether the kitchen
light or other kitchen
appliances are working.
0
and zeros
light up in the
display.
Power cut Reset the clock.
The oven does
not heat up.
There is dust on
the contacts.
Turn the control knobs back
and forth several times.
Error message Possible cause Remedy/information
“‹‚‚
A button was
depressed for
too long or is
covered up.
Press all buttons
individually. Check whether
any buttons are jammed,
covered up or soiled.