14
Cleaning the glass panels
The glass panels can be removed from the oven door for
cleaning.
ã=
Risk of burns!
Do not remove the panels immediately after switching the
appliance off. The oven must be cold.
Removal
1.
Open the oven door.
2.
Undo the two screws on the door using a flat-bladed
screwdriver (blade width 8-11 mm). Hold the door panel
firmly while doing this. (Fig. A).
3.
Close the door slowly and pull out the panel upwards by the
door handle. (Fig. B).
4.
Hold the panel firmly and push the catches on the door
upwards. Lift out the panel upwards. (Fig. C).
Notes
■
Clean the glass panel with glass cleaner and a soft cloth.
■
Do not use any sharp or abrasive agents. The glass scraper
is not suitable. The glass could be damaged.
Refitting
1.
Insert the panel and push it downwards until it engages. (Fig.
A).
2.
The lettering must be positioned in the top right corner, so
that it can be easily read. (Fig. B).
3.
Push the safety catches downwards. (Fig. C).
4.
Insert the panel into the guide, lift it slightly and locate it in
position at the top. (Fig. D).
5.
Lift the panel slightly and locate it in position at the top. (Fig.
E).
6.
Fully open the door, while holding the panels firmly with one
hand. (Fig. F).
7.
Tighten the screws hand-tight using a flat-bladed screwdriver
(blade width 8-11 mm), close the door. (Fig. G).
Caution!
The oven may only be used again when the panels are
correctly installed.
$
%
&
$
%
&
'
(
)
*
