en
Trouble shooting
24
--------
:
Warning – Risk of injury!
Incorrect repairs are dangerous. Do not attempt to
repair the appliance yourself. Repairs must only be
carried out by one of our trained after-sales engineers. If
the appliance is defective, call the after-sales service.
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Error messages on the display
If an error message with "
“
" appears on the display,
e.g.
“‹†
-
„ƒ
, touch the
v
button. This will reset the
error message. Reset the time, if necessary.
If the fault was a one-off, you can continue to use your
appliance as normal. If the error message appears
again, call our after-sales service and quote the exact
error message and the E no. of your appliance.
Maximum operating time
If you do not change the settings on your appliance for
several hours, the appliance will stop heating
automatically. This prevents unintentional continuous
operation.
When the maximum operating time is reached depends
on the various different settings that have been
configured on the appliance.
Maximum operating time reached
”‰
appears on the display.
Turn the function selector to the "Off" position. You can
configure new settings if required.
Tip:
To prevent the appliance from switching off when
you do not want it to, e.g. with an extremely long
cooking time, you should always set a cooking time.
The appliance will heat up until the set cooking time has
elapsed.
Replacing the bulb in the oven ceiling light
If the bulb in the oven light fails, it must be replaced.
Heat-resistant, 25 watt, 230 V halogen bulbs are
available from the after-sales service or specialist
retailers. When handling the halogen bulb, use a dry
cloth. This will increase the service life of the bulb. Only
use these bulbs.
:
Warning – Risk of electric shock!
Switch off the circuit breaker in the fuse box.
1.
Place a tea towel in the oven when it is cold to
prevent damage.
2.
Remove the glass cover. To do this, press the metal
tabs to the side with your thumb (Fig. A).
3.
Pull out the bulb (do not turn it ) (Fig. B). Insert the
new bulb, making sure that the pins are in the
correct position. Push the bulb in firmly.
4.
Refit the glass cover. When doing this, insert it on
one side and press firmly on the other side. The
glass cover will click into place.
5.
Remove the tea towel and switch on the circuit
breaker.
The appliance is
not heating. The
colon is flashing
on the display. On
some appliances,
a
š
will also
appear on the dis-
play.
Demo mode
is activated.
Briefly disconnect the appliance
from the mains (switch off the cir-
cuit breaker in the fuse box) and
then deactivate demo mode
within approx. 5 minutes by
changing the basic setting
™‚„
or
™›
to
‹
.
%
$
