35
SMS (Text Messages)
Gigaset S645 / GBR / A31008-M1634-L101-1-7619 / sms_BRD_neutral.fm / 27.08.2004
Sending the text message through
another SMS centre
¤
Activate the SMS centre (2 to 5) as a
send centre
.
¤
Send the text message.
Text message to PABXs
u
You can only receive an SMS if the
Call-
ing Line Identification
is forwarded to
the extension of the PABX
(CLIP).
The
CLIP evaluation of the number of the
SMS centre happens in your
Gigaset
.
u
You may have to prefix the access code
to the number of the SMS centre
(depending on your PABX). You can
store the access code in your base sta-
tion.
If in doubt, test your PABX e.g. by send-
ing a text message to your own
number: once with and once without
the access code.
u
When you send messages, your sender
number may be sent without your
extension number. The recipient can-
not reply to you directly in this case.
Sending and receiving text messages
on
ISDN PABXs
is only possible via the MSN
number assigned to your base station.
Activating/deactivating the
SMS function
After deactivating the function, you can-
not receive any more text messages and
your phone cannot send any.
The settings you made for sending and
receiving the text messages (numbers of
the SMS centres) and the entries in the
input and draft messages list remain
stored even after deactivating.
v
Open
menu.
5 4 O 2 L
Enter digits.
Q
§OK§
Deactivate the SMS function.
Or:
1
§OK§
Activate the SMS function
(factory setting).
SMS troubleshooting
Error codes when sending
Troubleshooting
The following table lists error situations
and possible causes and gives trouble-
shooting hints.
Note:
Ask your service provider what you need to
consider when entering the service numbers if
you want to use personal mailboxes (precondi-
tion: your service provider supports this func-
tion).
E0 Permanent suppression of the number
activated (CLIR) or Calling Line
Identification not released.
FE Error occurred during message transfer.
FD Error in connection set-up to SMS centre,
see self-help.
You cannot send messages.
1. The "Calling LineIdentification" (CLIP) fea-
ture is not requested.
¥
Have your service provider release the
feature.
2. Text message transmission has been inter-
rupted (e.g. by a call).
¥
Re-send the message.
3. The feature is not supported by the network
provider.
4. No number or a wrong number is entered
for the SMS centre activated as a send cen-
tre.
¥
Enter number (page 34).
You receive an incomplete text message.
1. Your phone's memory is full.
¥
Delete old text message (page 31).
2. The second service provider has not yet
transmitted the rest of the text message.