53
Troubleshooting
Gigaset C590/C595 / USA-CAN engl / A31008-M2101-R301-1-3S19 / appendix.fm / 19.04.2010
V
e
rsion 4, 16.0
9
.2005
Troubleshooting
If you have any questions about the use of
your telephone, you can contact us at any
time at www.gigaset.com/customercare.
The table below contains a list of common
problems and possible solutions.
The display is blank.
1. The handset is not switched on.
¥
Press and
hold
the end call key
a
.
2. The battery is dead.
Charge the battery or replace it
(
Not all menu options are displayed.
The menu display is reduced (
Standard mode
).
¥
Activate extended menu display (
Expert
mode
•
No Base
flashes on the display.
1. The handset is outside the range of the base.
¥
Move the handset closer to the base.
2 The range of the base is reduced because Eco
Mode is activated.
¥
Deactivate Eco Mode (
reduce the distance between the handset
and the base.
3. The base is not switched on.
Check the main adapter of the base
(
Please registerhandset
flashes on the display.
Handset has not been registered with the base or
has been deregistered.
¥
Register the handset (
Handset does not ring.
1. The ringtone is deactivated.
¥
Activate the ringtone (
2. The telephone only rings when the phone
number is transferred.
Activate the ringtone for anonymous calls
(
You cannot hear a ringtone/dialing tone from
the fixed line network.
The phone cord supplied has not been used or
has been replaced by a new cord with the wrong
pin connections.
¥
Please always use the phone cord supplied or
ensure that the pin connections are correct
when purchasing from a retailer (
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥
Reset the system PIN to 0000 (
You’ve forgotten the system PIN.
¥
Reset the system PIN to 0000 (
The other party cannot hear you.
You have pressed the MUTE key
h
. The handset
is "muted".
¥
Activate the microphone again (
The number of the caller does not display
despite CID.
Calling Line Identification (
CID
) is not enabled.
¥
The caller
should ask the network provider to
enable Calling Line Identification (
CID
).
You hear an error tone when keying an input
(a descending tone sequence).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the user guide if
necessary.
You cannot listen to messages on the network
mailbox.
Your PABX is set for dial pulsing.
¥
Set your PABX to tone dialing.
Содержание Gigaset C590
Страница 226: ......