Siemens Gigaset C350, Руководство пользователя

Страница: 9 / 55

6
Preparing to use the phone
Gigaset C350 / GBR / A31008-M1621-L161-1-7619 / starting.fm / 19.1.05
u
If you buy a replacement phone cord in
the shops make sure that the phone
jack has the correct type of wiring.
Setting up the handset for use
Inserting the batteries
¤
Fit the batteries with the correct polar-
ity.
Opening/closing the battery cover
¤
To close, position the cover 2 so that it
is open slightly and push it upwards
towards the loudspeaker 1 until it clicks
into place.
¤
To open, press down on the cover 2
below its upper end and slide it down
away from the loudspeaker 1 .
Placing the handset in the base and
registering it
¤
Place the handset in the charging cra-
dle of the base unit with its display fac-
ing forward .
The handset registers automatically.
Registration takes approx. 1 minute.
While this is happening,
Registering
appears in the display and the name of the
base, Base 1 , flashes. The handset is given
the lowest available internal number
(1–6). When the handset has registered,
this number appears in the display,
e.g. INT 1 . This means that the handset
has been allocated the first internal
number. If all internal numbers 1–6 have
been assigned (six handsets are registered
on a base), the number 6 is overwritten if
that handset is in idle status.
Correct phone jack wiring
1 unused
2 unused
3 a
4 b
5 unused
6 unused
Note:
Use only the rechargeable batteries recom-
mended by Siemens on page 39! Under no cir-
cumstances should you use a conventional
(non rechargeable) battery or other battery
types as this could cause significant damage to
health and property, e.g. the outer casing of
the batteries could be destroyed or the batter-
ies could explode. The phone could also mal-
function or be damaged as a result of using
batteries that are not of the recommended
type.
3
2
1 4
5
6
Note:
– Automatic registration is not possible when
the base on which you wish to register the
handset is being used to make a call.
– A key press cancels automatic registration.
– If automatic registration does not work the
handset will have to be registered manually
(page 27).
– The name of the handset can be changed
(page 30).
2
1