6
AL14H / EN-Master / A31008-M2050-R101-1-6Z19 / AL14H_EN.fm / 12.11.2008
Care
Wipe the base station, charging cradle and handset
with a
damp
cloth (do not use solvent) or an anti-
static cloth.
Never
use a dry cloth. This can cause static.
Contact with liquid
If the handset has come into contact with liquid:
1.
Switch off the handset and remove the bat-
tery pack immediately
.
2. Allow the liquid to drain from the handset.
3. Pat all parts dry, then place the handset with
the battery compartment open and the keypad
facing down in a dry, warm place
for at least
72 hours
(
not
in a microwave, oven etc.).
4. Do not switch on the handset again until it is
completely dry.
When it has fully dried out, you will normally be
able to use it again.
Questions and answers
If you have any questions about using your phone,
visit us at www.gigaset.com/customercare at any
time. The table below contains a list of common
problems and possible solutions.
Authorisation
This device is intended for use within the
European Economic Area and Switzerland. If
used in other countries, it must first be
approved nationally in the country in ques-
tion.
Country-specific requirements have been
taken into consideration.
We, Gigaset Communications GmbH, declare
that this device meets the essential
requirements and other relevant regulations
laid down in Directive 1999/5/EC.
A copy of the 1999/5/EC Declaration of
Conformity is available at this Internet
address:
Problem
Cause
Solution
Nothing
appears in the
display.
The handset is
not switched on.
Battery pack is
flat.
Press the end call key
a
for
approx. 5 sec-
onds
or place the hand-
set in the base station.
Charge/replace the bat-
tery pack (page 3).
No reaction to
key press.
The keypad lock
is activated.
Press the hash key
R
for
approx. 2 seconds
No wireless
connection to
the base sta-
tion,
Base
flashes in the
display.
The handset is
outside the
range of the
base station.
The handset is
not registered.
Move the handset
closer to the base
station.
Register the handset
!
