Siemens FIDAMAT 6, Руководство по эксплуатации, Страница: 73 / 202

Operation
7.4 Jump back to coded/decoded display mode
FIDAMAT 6
Operating Instructions, 01/2019, A5E00222135-04
71
7.4 Jump back to coded/decoded display mode
With the [MEAS] key, you return from "Operator control mode" back to "Decoded display
mode". Any input started is canceled.
Before the return, the following query appears:
Figure 7-5 Query before return
● Press "YES" to transfer the changes to the work memory of the parameter memory or
"NO" to discard the changes. The device then changes to "Decoded display mode".
● Press [ESC] to return to the last function screen. Changes are accepted here without a
query.
Coding the device
After the return to "Decoded display mode" with [ESC] or [MEAS], you put the device back
into "Coded display mode" by pressing [MEAS] again. Only now is function control
deactivated again.
7.5 Fast function selection
In order to directly access the desired function when operating frequently from the "Coded
display mode", a "Power user operation" was created. This allows you to directly access the
desired function by entering the function number. This allows you to skip menu levels.
However, the functions can only be directly called from "Coded display mode". For fast
function selection, proceed as follows:
1.
Enter the number of the desired function using the number keys.
2. Press the softkey of the component with the arrow ►. If the desired function is protected
by a code, you will be asked to enter the code.