Siemens FIDAMAT 6, Руководство по эксплуатации, Страница: 172 / 202

Technical specifications
11.3 Technical data of the FIDAMAT 6-G
FIDAMAT 6
170
Operating Instructions, 01/2019, A5E00222135-04
Table 11- 11 Technical specifications – Pressures and flow
Pressures and flow
Gases
Inlet pressure hPa
(rel.)
Operating pressure
hPa (rel.)
Flow through FID
ml/min Flow through by-
pass
ml/min
Without pump
start-up
With pump start-
up
Combustion gas 2000 ... 4000 1000 ± 20 ~ 12 -
Combustion air 2000 ... 4000 420 ± 20 500 ~ 320 ~ 500
Sample gas atmospheric - 500 ± 2 ~ 3 ~ 1000
Zero gas 2500 ... 3000 - 500 ± 2 ~ 3 ~ 1000
Calibration gas 2500 ... 3000 - 500 ± 2 ~ 3 ~ 1000
11.3 Technical data of the FIDAMAT 6-G
Table 11- 12 Technical specifications – General
General
Measuring ranges
4, internally and externally switchable;
manual and automatic measuring range switchover possible
Automatic measuring range switchover Hysteresis, selectable
Smallest possible span 0-10 ppm
Detection limit 0.03 ppm
Largest possible span 99.999 ppm
Concentration units (ppm) C1, C3, C6, mg C/m3
Measured value display Digital concentration display (5 digits with floating decimal
point)
Resolution of digital display 0.1% of measured value
Operating position Front panel vertical
Conformity CE marking EN 50081-1, EN 50082-2
Oven temperature Adjustable between 100 and 200 °C (depending on applica-
tion)
Table 11- 13 Technical specifications – Gas inlet conditions
Gas inlet conditions
Permissible sample gas pressure
Approx. 1,000 hPa
Sample gas flow rate 18 to 60 l/h (0.3 to 1 l/min)
Sample gas temperature 0-200 °C
Sample gas humidity < 90% relative humidity