Siemens FC300, Руководство по эксплуатации, Страница: 118 / 518

Auto Log Off function
With the "Auto Log Off" function enabled (default), you will be prompted to enter the password
if no keys have been pressed for ten minutes before operating the display again. With the "Auto
Log Off" function disabled, you will not be prompted to enter the password before operating
the HMI.
NOTICE
Device restart
Whenever the device is restarted, the access level is reset to Read Only.
7.2.1.3 Operation view
● The operation view can be displayed in up to six user-configured views. Switch manually
between the enabled views with the keys and . The actual operator view number (1
to 6) is shown in the upper right corner of the figures below.
The view types including the number of process values shown in the operation view are
configured in HMI menu structure (Page 481).
In view 1 only measurement or diagnostic views can be selected. In views 2 to 6 all view types
can be selected.
Navigation view can only be accessed by pressing the right key in a measurement or a
diagnostic view.
● Measurement views
– Single value
– Three values
– One value and bargraph
– One value and graph
– Six values
● Operating views
– Totalizer
– Dosing
● Alarm view
– Alarm List
● Diagnostic view
– Six Diagnostic Values
In general, all of the HMI views show the following:
Operating MASS 2100/FC300 with FCT030
7.2 Operating instructions
MASS 2100 & FC300 (FCT030)
118
Operating Instructions, 06/2017, A5E39789040-AA