Siemens ET6 DK Series, Инструкция по эксплуатации, Страница: 5 / 12

5
Residual heat indicator
The hob has a two-stage residual heat indicator for each
hotplate.
If • appears in the display the hob is still hot. It may be used,
for example, to keep a small meal warm or to melt cooking
chocolate. As the hotplate cools down further, the display
changes to œ . The display remains lit until the hotplate has
cooled sufficiently.
Setting discs
You can set the heat settings and the timer by turning the
setting discs.
You can remove the setting discs. This makes cleaning easier.
You can also remove the setting discs when the hotplate is in
operation. The hotplates switch off after 3 seconds. The
residual heat indicator H/h appears in the display.
If you refit the setting disc during operation, you can make new
settings.
Always place the setting disc in the recess with the high-gloss
side facing down.
Storing setting discs
The setting discs are magnetic. Keep the setting discs away
from magnetic data media, such as video cassettes, diskettes,
credit cards or cards with magnetic strips. The data these
contain could otherwise be wiped. They can also cause
interference in television sets and monitors.
:
For wearers of electronic implants, e.g. pacemakers or
insulin pumps.!
Implants could be affected by magnetic fields. You must
therefore never carry the setting discs in your pockets. They
must be kept at least 10 cm from pacemakers.
Note:
The setting discs are magnetic. Small metal parts which
attach themselves to the underside can scratch the surface of
the glass ceramic and front moulding. Always wipe and clean
the setting discs thoroughly.
Setting the hob
This section informs you how to set the hotplates. The table
shows heat settings and cooking times for various meals.
Switching the hob on and off
The main switch is used to switch the hob on and off.
To switch on: touch the
# symbol. A signal sounds. The ‹
hotplate indicators light up. The hob is ready for use.
To switch off: touch the
# symbol until the ‹ hotplate
indicators go out. All hotplates are switched off. The residual
heat indicator remains on until the hotplates have cooled down
sufficiently.
Note:
The hob switches off automatically if all hotplates have
been switched off for more than 10 seconds.
Setting a hotplate
Use the setting discs to set the desired heat setting.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
There is an intermediate setting between each heat setting. This
is identified by a dot.
To set the heat setting:
The hob must be switched on.
Select the hotplate. Turn the appropriate setting disc until the
heat setting indicator shows the desired heat setting.
The hotplate is switched on.
To change the heat setting:
Use the setting disc to set the new heat setting.
To switch off the hotplate:
Use the setting disc to adjust the setting to
‹
. After about
10 seconds, the residual heat indicator appears.
Note:
Hotplate temperature is regulated by the heat switching
on and off. The heat may also switch on and off at the highest
setting.