en
Operating the appliance
22
1
Operating the appliance
Operating
the appl
iance
In this section, you can find out how to set your
appliance. In the table, you can find the settings for
various dishes.
Grilling with water and lava stones
Note:
Fill the grill container with water before each use.
Otherwise the appliance will overheat.
The amount of water depends on whether you want to
use lava stones. The lava stones store the heat from the
grill element, leading to intense radiation of heat and
even heat distribution.
Filling with water and lava stones
1.
Remove the wire rack and fold up both grill
elements. Remove the lava stone container from the
appliance.
2.
Ensure the drain valve is closed.
3.
Pour water into the grill container.
Grilling with lava stones: 1 litre (bottom mark)
Grilling without lava stones: 3.5 litres (top mark)
4.
To grill with lava stones: Remove the lava stones
from the packaging and place them in the lava stone
container. Place the lava stone container into the
appliance.
5.
Fold down the grill heating element and replace the
wire rack.
The grill is ready to use.
Switching on or off
Note:
The appliance switches off automatically when
the grill setting remains at 0 for more than 20 seconds.
Switching on
Touch the
#
symbol.
An audible signal sounds. The indicator above the main
switch lights up. The appliance is ready to use.
Switching off
Touch the
#
symbol until the indicator above the main
switch goes out.
The appliance is switched off. The residual heat
indicator remains lit until the appliance has cooled
down sufficiently.
Setting the grill
Set the desired grill setting on the control panel.
Grill setting 1 = lowest output
Grill setting 9 = highest output
Setting the grill setting
1.
Switch on the grill using the main switch
#
.
2.
Use the
ø
,
‘
or
’
symbols to select both or just one
of the heating elements.
‹
lights up in the grill setting display.
3.
Slide your finger along the control panel until the
required grill setting appears on the display.
The heating indicator flashes.
Note:
The grill regulates the temperature by switching
the grill element on and off. The grill element may
switch on and off even at the highest setting.
Preheating the grill
Only place food on the grill when the preheating time
has elapsed. The preheating symbol goes out. During
the preheating time, the grill heats up at full power.
Thereafter, the temperature is reduced by the heating
elements being switched on and off in order to maintain
a constant temperature for the respective setting.
The preheating time can be between 8 and 10 minutes,
depending on the grill setting.
Note:
Preheat the empty grill for a maximum of 8-12
minutes. A longer preheating time could result in the
appliance switching off (overheating protection). Switch
the appliance off and leave it to cool down before
switching it on again.
Ñ
³
«
S
f
S
