Siemens EP6A Series, Инструкция по эксплуатации

Страница: 6 / 16

en
Getting to know your appliance
6
:
Warning – Risk of injury!
■
Cracks or fractures in the glass plate are
dangerous. Shut immediately off all burners
and any electrical heating element. Unplug
the appliance from the mains or switch off
the circuit breaker in the fuse box. Shut off
the gas supply. Do not touch the appliance
surface. Never switch on a faulty appliance.
Contact the after-sales service.
Risk of injuries!
■
Sudden changes in temperature may cause
breakage of the glass. While using your
hob, prevent any draughts and do not spill
any cold liquids on it.
Risk of injuries!
■
Pans which are damaged, are not the right
size, hang over the edge of the hob or are
not positioned correctly can cause serious
injuries. Follow the advice and warnings
provided relating to the cooking pans.
Risk of injury!
■
Incorrect repairs are dangerous. Repairs
may only be carried out, and damaged
power and gas lines replaced, by an after-
sales engineer trained by us. If the
appliance is faulty, unplug the mains plug or
switch off the fuse in the fuse box. Shut off
the gas supply. Contact the after-sales
service.
Risk of injury!
■
If a control knob is too stiff to turn or it is
loose, it must not be used. Contact our
after-sales service immediately to have the
control knob repaired or replaced.
:
Warning – Risk of electric shock!
■
Do not clean the appliance using steam
cleaners.
Risk of electric shock!
■
Cracks or fractures in the glass plate could
cause electric shocks. Switch off the circuit
breaker in the fuse box. Contact the after-
sales service.
*
Getting to know your
appliance
Getting to know your appliance
You can find your appliance and the burner powers in
the model overview.
~
Page 2
Controls and burners
Each control knob is marked with the burner it controls.
You can use the control knobs to set the output
required in each case to various positions between the
maximum and the minimum settings. Never try to switch
directly from position 0 to position 1 or from position 1
to position 0.
It is essential to ensure that all the burner parts and pan
supports are correctly installed for the appliance to
work correctly. Do not swap the burner caps around.
Always remove the pan supports carefully. When
moving a pan support, the pan supports next to it may
also move.
Indicators
¼
Burner controlled by control knob
Ú
Switched-off burner
9 Highest power setting and electric ignition
1 Lowest power setting
Elements
1 Ignition plug
2 Thermocouple
3 Burner cup
4 Burner cap