Siemens ED FQ1 Series, Инструкция по эксплуатации, Страница: 18 / 36

en
PowerBoost function
18
Once the time has elapsed
The hotplate switches off. A warning signal sounds. The
time program function lights up
‹‹
for 10 seconds in
the display.
When the
0
symbol is pressed, the indications turn off
and the beeping stops.
Notes
■
If a cooking time was programmed for several
hotplates, the time information for the selected
hotplate is shown in the timer display.
■
You can set a cooking time of up to 99 minutes.
The kitchen timer
You can use the kitchen timer to set a time of up to 99
minutes.
This functions independently from the hotplates and
from other settings. This function does not automatically
switch off a hotplate.
Programming
1.
Press the
0
symbol several times until the
W
indicator lights up.
‹‹
lights up in the time program
function display.
2.
Select the desired time in the programming panel.
The timer starts to count down after a few seconds.
Changing or cancelling the time
Press the
0
symbol several times until the
W
indicator
lights up. Change the time with the programming zone,
or set to
‹‹
.
Once the time has elapsed
A warning signal sounds. In the time program function
display
‹‹
is shown, and the
W
indicator lights up.
After 10 seconds the indicators turn off.
When the
0
symbol is pressed, the indicators turn off
and the beeping stops.
v
PowerBoost function
PowerBoost function
The PowerBoost function enables you to heat up large
quantities of water faster than when using heat setting
Š .
This function can always be activated for a hotplate,
provided the other hotplate in the same group is not in
use (see illustration). Otherwise, › and Š will flash in
the display for the selected hotplate; the Š heat setting
will then be set automatically without activating the
function.
Note:
In the combi zone, the PowerBoost function can
only be activated if the two hotplates are used
independently of each other.
Activating
1.
Select a hotplate.
2.
Select the Š heat setting and then touch the &
symbol. The › indicator lights up.
The function was activated.
Deactivation
1.
Select the hotplate.
2.
Touch the
&
symbol.
The
›
display goes out and the hotplate switches
back to the
Š
heat setting.
The function is deactivated.
Note:
In certain circumstances, the PowerBoost
function can switch itself off automatically in order to
protect the electronic elements inside the hob.