Installation Instructions
Document No. 565-718
December 15, 2009
CSI Host Driver for PXC Modular
These installation instructions cover the connection of
the CSI Host Driver to the CSI System. For hardware
installation of the PXC Modular, see document
number 553-638.
Product Description
The CSI Host Driver enables communication
between the APOGEE
®
Automation System and the
CSI system.
Product Numbers
PXC00-PE96.A
PXC Modular RS-485 or Ethernet
ALN, 96 FLN nodes
PXC00-E96.A
PXC Modular with BACnet/IP
ALN and BACnet MS/TP ALN, 96
FLN nodes
PXC100-PE96.A
PXC Modular RS-485 or Ethernet
ALN, TX-I/O Support, 96 FLN
nodes
PXC100-E96.A
PXC Modular BACnet/IP ALN
and BACnet MS/TP ALN, TX-I/O
Support, 96 FLN nodes
PXX-485.3
Expansion Module, three RS-485
FLN connections
LSM-INT-CSIHOST
License for CSI Host PXC
Modular Driver
Accessories
538-670
Trunk Interface II, 115V
538-675
Trunk Interface II, 230V
536-004
Modem Cable, DB-9 Female/DB-25
Male, Serial
Warning/Caution Notations
WARNING:
Personal injury/loss of life may occur if you
do not follow the procedures as specified.
CAUTION:
Equipment damage or loss of data may
occur if you do not follow the procedures
as specified.
Expected Installation Times
The expected installation time is 30 minutes.
Required Tools and Materials
•
Flat-blade screwdriver (1/8-inch blade width).
•
Wire strippers.
•
Cabling and connectors. See the
Connecting
the CSI Host Driver to the CSI System
section.
CAUTION:
Always wear an electro-static discharge
wrist strap and discharge accumulated
static before touching field panel
components.
Prerequisites
•
Driver hardware is installed according to its
respective installation instructions.
•
FLN Termination blocks installed, if any.
Depending on the type of installation, other
prerequisites may have to be completed.
Item Number: 565-718, Rev. AA
Page 1 of 4