Siemens CP 1542SP-1, Руководство по эксплуатации

Страница: 17 / 118

Application and functions
1.4 Telecontrol communication (CP 1542SP-1 IRC)
CP 154xSP-1
Operating Instructions, 12/2019, C79000-G8976-C426-05
17
● DNP3 *
The CP functions as a DNP3 station (outstation).
Communication is based on the DNP3 SPECIFICATION Version 2.11 (2007/2009).
You will find a detailed overview of the attributes and properties of the DNP3 protocol that
are supported by the CP in the DNP3 device profile; see
Link: ( https://support.industry.siemens.com/cs/ww/en/ps/22143/man )
Communications partners of the CP can be:
DNP3 master:
–
SIMATIC PCS 7 TeleControl
– SIMATIC WinCC TeleControl
– SIMATIC WinCC OA
– A TIM module with DNP3 capability (TIM 3V IE DNP3 / TIM 4R IE DNP3)
For the manual of the TIM module see /5/ (Page 114).
– Third-party systems that support the DNP3 specification named above.
DNP3 stations (outstation):
–
CPUs in stations
For direct communication, the "Master function" is enabled for the sending data point.
● IEC 60870-5-104 *
The CP functions as a substation (slave).
Communication is based on the specification IEC 60870-5 Part 104 (2006).
You will find a detailed overview of the attributes and properties of the IEC specification
that are supported by the CP in the IEC device profile; see
Link: ( https://support.industry.siemens.com/cs/ww/en/ps/22143/man )
Communications partners of the CP can be:
IEC master:
–
SIMATIC PCS 7 TeleControl
– SIMATIC WinCC TeleControl
– SIMATIC WinCC OA
– Third-party systems that support the IEC specification named above.
Stations:
–
CPUs in stations
For direct communication, the "Master function" is enabled for the sending data point.
* Optional telecontrol communication with the master station via SINEMA Remote Connect,
see section Communication via SINEMA RC (CP 1542SP-1 IRC, CP 1543SP-1) (Page 18).