Hardware Installation
13
Siemens Building Technologies
Fire Safety & Security Products
01.2006
5 Hardware
Installation
This chapter will guide you through the correct installation procedures for the LCD
monitor.
5.1
Scope of Delivery
z
One LCD monitor mounted on its stand
z
AC power cord
z
User manual
z
PC DVI-A to D-sub 15-pin cable
z
DC 12V 500mA Output Power Cord (CMTC1915 only)
z
Remote controller (CMTC1915 only)
5.2 System
Requirements
z
This LCD monitor DOES NOT require any special drivers.
For PC system applications with a DVI-D & D-sub analog input source, the
necessary drivers are supplied by the video card manufacturer and may be
found on the diskettes supplied with the video card that came with your
computer. Windows 98/XP/2000 drivers for both the display and the video card
are supplied on the Windows 98/XP/2000 CD or diskettes. Unfortunately,
Microsoft did not provide a complete listing of the monitors at the time of the
initial retail release.
z
You may use the standard SXGA (1280x1024) for 17” & 19” LCD monitors and
XGA (1024x768) for 15” LCD monitors as the monitor type.
z
The video card must also be set up correctly in Windows 98/XP/2000.
Make sure that the video output of the VGA card is listed in chapter 7: The
Display Timing of PC Mode or check your video card manual or Windows
98/XP/2000 “Read Me” file for further information on the video card.
After these issues have been resolved, continue the setup procedure as described
below.
