Disposal
en
27
Fault
Cause and troubleshooting
Appliance does not
heat up.
There has been a power cut.
▶
Open and close the appliance door once after a power failure.
a
The appliance is checked and is ready to use.
The time is not dis-
played when the ap-
pliance is switched
off.
Basic setting has been changed.
▶
Change the basic setting for the time display.
→
Home Connect is not
working properly.
Different causes are possible.
▶
Go to www.home-connect.com.
During simple mi-
crowave operation,
the cooking compart-
ment becomes hot.
The drying function is switched on.
To prevent condensation from forming when the appliance is in microwave-only mode, the
appliance automatically switches on an additional heating element when it is set to 600 W
or 900 W. The cooking result is not affected by this.
▶
You can change the basic setting for the drying function during microwave operation.
→
‒
Observe the information on operating with microwave.
→
The interior lighting
does not work.
The LED light is defective.
▶
Call the after-sales service.
→
Maximum operating
time reached.
To prevent an unwanted permanent operation, the appliance automatically stops heating
after several hours if the settings are unchanged. A message appears in the display.
The point at which the maximum operating time is reached is determined by the corres-
ponding settings for an operating mode.
1.
To continue operation, switch the appliance off and on again using . Reset and start
the operation.
2.
If you do not need to use the appliance, press to switch it off.
Tip:
To prevent the appliance from switching off when you do not want it to, set a cooking
time.
→
"Time-setting options", Page 14
Error code made up
of letters and num-
bers appears on the
display, e.g. E0111.
The electronics have detected a fault.
1.
Switch the appliance off and on again.
a
If the fault was a one-off, the message disappears.
2.
If the message appears again, call the after-sales service. Please specify the exact error
message when calling.
→
The cooking result is
not satisfactory.
Settings were unsuitable.
Adjustment values, e.g. temperature or cooking time, depend on the recipe, quantity and
food.
▶
Next time, set lower or higher values.
Tip:
A lot of other information about the food preparation and corresponding adjustment
values can be found in the Home Connect app or on our website siemens-home.bsh-
group.com .
22 Disposal
22.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
1.
Unplug the appliance from the mains.
2.
Cut through the power cord.
3.
Dispose of the appliance in an environmentally
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
This appliance is labelled in accord-
ance with European Directive
2012/19/EU concerning used elec-
trical and electronic appliances
(waste electrical and electronic equip-
ment - WEEE).
The guideline determines the frame-
work for the return and recycling of
used appliances as applicable
throughout the EU.
Содержание CM924G1 1B Series
Страница 43: ......
