Siemens Arcteq AQ01, Инструкция по эксплуатации

Страница: 23 / 48

Instruction manual AQ101, AQ101D, AQ110P, AQ01 23 (48
)
3.1.3 S
ET BUTTON
All devices contain a set button in the front panel, which is used for installing the
system, checking the number of connected sensors and units, resetting the device
after trip event and clear the alarm signals.
Figure 3-2: Set button.
Function Instruction Indications
Install (add binary input or
sensor amount) the system
configuration
Press the button for 3 seconds All connected inputs LED’s lit
steadily during installation.
Install (reduce binary input or
sensor amount) the system
configuration
Switch any DIP switch back and
forth one time, press the button
for 3 seconds
All connected inputs LED’s lit
steadily during installation.
Clear the alarm signals Press the button once Respective blinking led indicators
turns off
Check the number of installed
sensors and unit connections
(Binary inputs) *
Press the button 3 times within 2
seconds.
Corresponding connected input
LED blinks showing amount of
connected units and sensors.
Reset after trip or sensor or
binary input activation
Press the button once Corresponding activated signals
and LED’s turns off. Also latched
outputs resets.
Table 3-3: Set button function vs. indication behaviors.
*) Only available at AQ101, AQ101D and AQ110P.