Siemens 9810 Series, Руководство пользователя, Страница: 23 / 218

Installation and commissioning
The option modules are monitored and controlled by the meter’s ION modules.
External I/O modules are mapped to the corresponding ION modules:
Option module characteristic ION module characteristic
Physical position: Module A to Module D ION module label: Port A to Port D
Analog inputs A1 to A(n) Analog Input module A1 to A(n)
Analog outputs Q1 to Q(n) Analog Output module Q1 to Q(n)
Digital inputs S1 to S(n) Digital Input module S1 to S(n)
Digital/relay outputs R1 to R(n) Digital Output module R1 to R(n)
Maximum number of option modules
The maximum number of option modules supported by the device is four.
However, there are limitations.
Depending on the type and quantity of option modules attached to your meter, you
may need to reduce your meter’s maximum operating temperature or limit the
number of option modules. Refer to
Maximum operating temperature with option
modules, page 214 for more information.
NOTICE
EQUIPMENT DAMAGE
Failure to follow these instructions can result in equipment damage.
Do not exceed the maximum number of option modules.
Commissioning
Factory default settings
Use these default values the first time you connect to your meter.
Parameter Default value
Password to log onto meter webpages or access display 0
Username to log onto meter webpages 9810
IP address 1 169.254.0.10
Subnet mask 255.255.0.0
Gateway 0.0.0.0
RS-485 COM1 Unit ID: 100
COM4 Unit ID: 103
Language English
1 The IPv6 link local address can also be used. Refer to “Self-discovery over Ethernet”, page 28 for
details.
Commissioning using ION Setup
Use ION Setup to commission the meter for integration into your energy
management system.
Connect to your meter using ION Setup then use the Setup Assistant to configure
the meter. Setup parameters are arranged in logical groupings and category
folders.
7EN05-0390-00 23