Siemens 6RA7013-6DV62, Руководство по эксплуатации

Страница: 557 / 734

05.05 Parameter list
SIEMENS AG 6RX1700-0AD76
11-93
SIMOREG DC Master Operating Instructions
PNU
Description Value range
[Unit]
Steps No. indices
Factory
setting
Type See
Change
(Access /
Status)
P826
(G163)
Correction of natural commutation timing
If there is a variation in the armature current peak value (in spite of a
constant firing angle), it can be corrected by offsetting the firing angle
reference time of the appropriate line phase in parameter P826. One line
phase (UV, UW, VW, VU, WU, WV) is assigned to each parameter index
(i001 to i006).
Increasing the parameter setting by a value of 1 corresponds to an increase
of 1.333 µs in the firing angle (0.024 degrees at 50Hz line frequency),
consequently reducing the armature current peak in the appropriate line
phase.
P826 is automatically set during the optimization run for precontrol and
current controller (armature and field) (P051=25) (only when U800=0; when
U800=1 or 2, parameters P826.001 to 006 are set to 0).
Caution:
Even an asymmetrical system causes variations in the magnitude of
armature current peaks. However, the system asymmetry may also change.
-100 to 100 * 1.333
[µs]
1.333µs Ind: 6
FS=0
Type: I2 P052 = 3
P051 = 40
Online
r827 Internal diagnosis
i001: Number of write access operations to EEPROM
i002: Number of Page-Write access operations to EEPROM
i003: Counter for DUAL-PORT RAM timeouts
0 to 65535
1 Ind: 3
Type: O2 P052 = 3
r828 MLFB data
These data contain details about the power section design (model)
0 to 65535
1 Ind: 16
Type: O2 P052 = 3
r829 A7001 compensation values
These data contain compensation values for the analog section of
electronics board A7001
0 to 65535
1 Ind: 68
Type: O2 P052 = 3
11.44 Thyristor diagnosis
P830
* Control word for thyristor diagnosis
0 Thyristor check function deactivated
1 Thyristors are checked on initial SWITCH-ON or INCHING
command after connection of the electronics supply voltage.
2 Thyristors are checked on every SWITCH-ON or INCHING
command.
3 Thyristors will be checked on the next SWITCH-ON or INCHING
command. Parameter P830 is set to 0 if no fault is detected.
Note:
The thyristor check function may not be activated (setting P830=0 must be
selected)
−
when the ”Enable a torque direction for torque direction change by
parallel drive” function is in use (see also parameter P165) or
−
when the converter is used to supply large inductances (e.g. field supply
from armature terminals, supply of lifting solenoids, etc.).
0 to 3
1 Ind: None
FS=0
Type: O2 P052 = 3
P051 = 40
Offline
11.45 Parameters for DriveMonitor and OP1S
P831
to
r849 Parameters for the Trace function of DriveMonitor
These parameters are settings for the data exchange between DriveMonitor
and the SIMOREG converter. They must not be changed!
P052 = 3
r850
to
P899 Parameters for the OP1S
These parameters are settings for the data exchange between OP1S and
the SIMOREG converter. They must not be changed!
P052 = 3