Siemens 6GA7202-2AA10-1BF1, Руководство по эксплуатации, Страница: 153 / 168

Chapter What needs to be done? OK?
Application
(Page 67)
SIMOCRANE CenSOR commissioning (applies to both versions)
→ Settings → Options
• "Lighting" group - select lamp
• "Lens" group - set the focal length
→ Application → Program
• Create a new program or select an existing
program
→ Application → Program → Image acquisi‐
tion "Image" group - set exposure time and bright‐
ness
"Trigger" group - set acquisition interval
"Lighting" group - select lamp and activate
flash (if installed)
→ Application → Program → CenSOR "Reflector parameters" group → set the following pa‐
rameters:
• Main reflector, Reflector alignment
• Main reflector, Reflector size
• Activate additional reflector (if installed)
• Additional reflector, Reflector size (if nec‐
essary)
"Image processing parameters" group → set the fol‐
lowing parameters:
• Minimum reflector contrast
• Edge determination threshold
• Probability of detection
• Edge smoothing filter
• Activate exposure control
• Control Gain
• Amount of Brightness
"Measured values for parameters" group → set the fol‐
lowing parameters:
• Activate "External Distance" input value (if
required)
• Determine and enter scale and offset for
external distance (if necessary)
• Offset and smoothing time for all meas‐
ured values
• Reflector distance limit
→ Application → Program • Save program and start processing
Calibration (Page 86) → Libraries → CenSOR calibration • Perform the calibration steps
Connection to a con‐
troller (Page 119) Connect SIMOCRANE CenSOR to a controller
• Connect SIMOCRANE CenSOR via PROFI‐
NET IO (Page 120)
• Connect SIMOCRANE CenSOR with UDP
via Ethernet (Page 128)
Checklist "Installation/connection", "Application", "Calibration", "Connection to a controller"
Appendix
A.2 "Commissioning" checklist for SIMOCRANE CenSOR
SIMOCRANE CenSOR
Operating Instructions, 07/2021
151