Programming
5.3 FC ECC4100 parameters
Technology module TM ECC 2xPWM ST (6FE1242-6TM10-0BB1)
44
Manual, 04/2018, A5E42681298B-AA
Output parameters
Table 5- 2
List of output parameters
Parameter
Data type Description
State
Byte
Charging state
The state is output at this output largely according to IEC 61851-1.
•
0: Charging outlet blocked
(no state according to IEC 61851-1)
•
1: State A
(state according to IEC 61851-1)
•
2: State B
(state according to IEC 61851-1)
•
3: State C
(state according to IEC 61851-1)
•
4: State D
(state according to IEC 61851-1)
•
5: State E
(state according to IEC 61851-1, but is also displayed in case of CP error; the voltage
at the CP output remains at +12 V, PWM is disabled in this case)
•
6: State F
(state according to IEC 61851-1)
CP_MaxVoltage Real
Max. CP voltage value (in Volt)
ContactorContr Bool
Load contactor state (module DQ state) (True = contactor on; False = contactor off)
This output can be used for additional evaluations of the load contactor state in the TIA
application (e.g. counting switching cycles for maintenance purposes).
LockControl
Bool
Locking (True = yes), Unlocking (False = no)
This output can be used for additional evaluations of the locking state in the TIA application
(e.g. for external control of locking the charging cable connector).
VentilationReq
Bool
Ventilation required (True = yes, False = no)
This output signals that ventilation must be connected (State D according to IEC 61851-1).
PWM_State
Bool
PWM enabled (True = on, False = off)
This output indicates whether PWM is switched on or off. PWM is disabled in case of CP
voltage errors, locking feedback errors or ventilation feedback errors. This signals to the
vehicle that charging is not possible under these circumstances.
MaxCableCurr
Real
Maximum detected current carrying capacity of the cable in ampere based on PP evalua-
tion
PWM_MaxCurr Real
Charging current [in ampere] signaled to the vehicle using PWM
(minimum of the three values "FC input MaxCurr", "Current carrying capacity of the cable"
and the parameter "Maximum charging current")
