Siemens 6DL2804 Series, Руководство по установке оборудования

Страница: 20 / 67

Mounting
4.1 Transport and storage
Distributed I/O device 6DL2804-xxxxx
20
Hardware Installation Manual, 03/2014, A5E00378896F-03
4.1 Transport and storage
Pack and store the enclosure for transport or storage so that there can be no undue strain on
the enclosure, particularly on its top cover. If there is too much strain on the top cover of the
enclosure, this can damage the seal.
Do not place the enclosure on the cable glands fitted in its base, otherwise the glands will be
damaged.
4.2 Mounting the enclosure
The enclosure is intended for wall mounting and should be secured with the wall supports
supplied with it. Use the following template for the drilling.
Figure 4-1 Drilling template for securing the device
CAUTION
Danger of injury when the enclosure is opened
When opening the enclosure with pivoting cover, the cover is pressed upwards by means of
the pressure of the dampers. When opening, press against the cover with your hand.
Note
•
Remember the maximum thermal load on the cables and wiring. The degree of protection
is only ensured when suitable cables and wires are used and correctly installed.
• Note that it is only permitted to connect and disconnect the cables to the power supply
module if the module has been powered down.
•
The degree of protection is reduced when the enclosure is mounted vertically.