Installation and operating instructions
MSA400 smart
05.2017
9
7. Installation
7.1 Installation requirements
General information about installation
• The following description of the assembly process is a recommendation from SIEGENIA and describes the major steps
involved. The specific details of the assembly process are determined, amongst other factors, by the sliding element used,
by the production process and by the window manufacturer's equipment and facilities.
• You will find specific steps for installation of the MSA400 smart on our download portal:
downloads.siegenia.com/de/00007/index.html
Risk of mechanical defects if the MSA400 smart system is put into operation
unassembled.
›
You must assemble the MSA400 smart first before putting it into operation!
Sliding element requirements
• The sliding element must not be warped.
• The sliding element must be installed vertically plumb in the reveal.
• The threshold must be properly and sufficiently supported — especially with wide or heavy sliding elements (e.g. 400 kg).
• The displacement force must not be > 60 N.
• The cable routing of the cable in the sliding sash must be checked prior to assembly. The sliding sash must be prepared
for an optimum cable channel in the eurogroove.
• The concealed mains cable guide must be located on the horizontal top section of the frame near the locking side.
Requirements to be met by the hardware
• The hardware must be able to run smoothly (be in unrestricted working order).
Requirements to be met by the drive
Risk of mechanical defects if the MSA400 smart system is put into operation with
sliding elements which cannot move freely.
›
Only put MSA400 smart into operation if the smooth running of the sliding element can be ensured!
• The MSA400 smart system has not been tested as a locking unit in accordance with ENV 1627-1630.
7.2 The connection of external operator push buttons and locking motor (not included in scope of delivery)
• You can also connect an optional external operator push button and a locking motor to the MSA400 smart system,
maximum connection 24V DC 1A.
1
2
3
4
1
Locking motor
2
3 Operating push
button
4
